Source-Reported Dosage & Concentration Guide
These figures are third-party educational claims, shown without converting them into a personal-use instruction.
| Vial / format | Source concentration | Source-listed amount | Source frequency |
|---|---|---|---|
| 10 mg Vial | 3.33 mg/mL | 300 mcg–500 mcg | Daily |
| 5 mg Vial | 1.67 mg/mL | 300 mcg–500 mcg | Daily |
Values are not a prescription, recommendation or evidence of safety. Recalculate only within a documented laboratory protocol.
Reconstitution Steps
- Use a sterile syringe to draw the validated diluent volume specified by the selected vial-format table, product label or approved laboratory method.
- Inject the diluent slowly down the inside wall of the vial; avoid directing the stream onto the material and avoid foaming.
- Gently swirl or roll until fully dissolved. Do not shake.
- Label the vial with product, concentration, diluent, preparation date and operator; protect from light and refrigerate at 2–8 °C (35.6–46.4 °F) unless the product-specific method states otherwise.
- Use within the product-specific validated hold time and no later than 4 weeks after preparation unless published stability data supports a different period.
Injection Technique
Use this technique only when the product-specific approved label or authorized research protocol specifies subcutaneous administration and trained personnel are responsible for the procedure.
- Clean the vial stopper and the selected administration site with alcohol; allow both surfaces to dry completely.
- Pinch a small fold of skin and insert the needle into the subcutaneous tissue at a 45–90° angle.
- Do not aspirate during a subcutaneous injection; deliver the validated volume slowly and steadily.
- If the approved protocol specifies a volume greater than 1.0 mL, divide it between separate sites rather than using one site.
- Rotate sites systematically; commonly referenced subcutaneous sites include the abdomen, thigh and upper arm.
- Wait several seconds after delivery before withdrawing the needle to help ensure the complete validated volume is delivered.
- Discard the used syringe immediately in an approved sharps container; never recap or reuse it.
Supplies Needed
- Product vial (Selank; use the selected labelled vial strength).
- U-100 insulin syringe (1 mL capacity) or the sterile administration device specified by the approved protocol.
- Validated diluent in the container size specified by the product label or authorized preparation method.
- Alcohol swabs and an approved sharps container—use a fresh swab for the vial stopper and each administration site.
Storage Instructions
Proper storage helps maintain product quality and stability. The supplied label, COA and product-specific validated method take precedence over these general handling rules.
- Unopened: Keep the vial sealed, dry and protected from light at the temperature stated on the supplied label; do not assume a universal shelf life.
- After preparation: Refrigerate at 2–8 °C (35.6–46.4 °F) unless the product-specific method states otherwise, and use only within its validated in-use period.
- Before opening a cold vial, allow the sealed container to equilibrate as required by the method so condensation does not enter the product.
- Long-term storage: Freeze or aliquot only when supported by product-specific stability data; avoid repeated freeze–thaw cycles and discard material with unexpected particles, discoloration or container damage.
How This Works
Selank is a synthetic heptapeptide based on the tuftsin sequence. Human and preclinical research examines anxiety-related measures, neurotransmitter and immune signaling, EEG patterns and functional brain connectivity, most commonly using intranasal delivery.
Chemical identity or a proposed mechanism does not establish an effective amount, treatment indication or safe human-use protocol.
Benefits & Side Effects
Benefits
- No established clinical benefit: Research findings do not by themselves establish an approved indication, clinical benefit or appropriate human-use protocol.
Side Effects & Evidence Limits
- Benefits are not assumed: The existence of a product or study does not establish a clinical benefit.
- Adverse effects depend on identity and route: Risk cannot be generalized across peptide classes, molecular forms or preparations.
- Interactions and contraindications: These require official labeling or qualified clinical review where an approved medicine exists.
- Research-use limitation: Unapproved products may lack adequate human safety, pharmacokinetic and long-term outcome data.
This material is provided for educational and laboratory reference only. It is not medical advice, a clinical protocol, or a recommendation for human or veterinary administration. Consult qualified professionals and applicable regulations before planning research.